Home / Crystal Clean Pages / How To Setup A Crystal Clean System

How To Setup A Crystal Clean System


How To Setup A Crystal Clean System remove iron system

install2Insert Feed Tube

Feed tubing as far as possible down into the pipe along the inside of your salt brine tank. This allows our liquid to drip directly into the salt water.  Be sure not to cut-off the extra tubing because the excess will be needed later on.

install1Add Treatment To Gallon Bottle

Use our Crystal Clean Dosage Calculator to determine how much Crystal Clean Concentrate you should add to the gallon bottle. The Iron Eliminator Kit ships with two bottles worth of concentrate already in the one gallon container.

install3Fill With Distilled Water

Add distilled or reverse osmosis water to the one gallon jug, filling it the rest of the way to the top. This diluted mixture will last exactly 4 months. Distilled or RO water are only required for the first gallon. Every other refill can be done with your softened water.

install4Insert Tube Into Bottle

Feed the tube with the cap into the one-gallon bottle and screw on tight. Be sure to position the tubing so it is as close to the bottom of the bottle as possible.

install5Mount The Pump To The Brine Tank

Mount the pump on the outside of your brine tank (or to the outside of your all-in-one softener) with the included high-strength velcro tape. Be sure to secure the excess tubing without cutting the slack because you will need that slack in the years to come.

install6Plug In The Pump

Plug the pump into any standard wall outlet. Our auto-dispenser runs 24/7, so installing the pump is very easy because it does not need to be hard-wire installed.  This pump will empty your one-gallon container in exactly 4 months.